How To Refelt Pool Table Rails

Refelting pool table rails is a relatively simple process that can be completed in a few hours. However, it is important to take your time and follow the instructions carefully to ensure a professional-looking finish.

Materials needed:

New pool table felt
Scissors
Staple gun
Staples
Hammer
Nail set
Chalk

Instructions:

Remove the old felt. Start by removing the old felt from the rails. Use a sharp knife to carefully cut along the seam of the felt, being careful not to damage the wood underneath.
Clean the rails. Once the old felt is removed, use a damp cloth to clean the rails. This will remove any dust or debris that may interfere with the adhesion of the new felt.
Apply the new felt. Start by applying the new felt to the bottom of the rail. Use a staple gun to secure the felt in place, spacing the staples about 1 inch apart.
Stretch the felt. Once the felt is stapled in place, use your hands to stretch it taught. Be careful not to stretch the felt too much, as this can cause it to tear.
Trim the excess felt. Once the felt is stretched, use a sharp knife to trim the excess felt around the edges of the rail.
Secure the felt. Use a hammer and nail set to secure the felt to the rail. Start by driving a nail into the center of each staple. Then, drive a second nail into each side of the staple.
Chalk the felt. Once the felt is secured, use a piece of chalk to rub over the surface. This will help to remove any excess moisture and give the felt a smooth finish.

Refelting pool table rails is a relatively simple process that can be completed in a few hours. By following these instructions, you can ensure a professional-looking finish that will last for years to come.