How To Felt Pool Table Bumpers

How to Felt Pool Table Bumpers

Pool table bumpers are an essential part of the game, providing a smooth and consistent playing surface. Over time, however, bumpers can become worn and damaged, affecting the playability of the table. Felting pool table bumpers is a relatively simple process that can be done at home with a few basic tools and materials.

Materials You'll Need:

New pool table felt
Staple gun
Scissors
Hammer
Flathead screwdriver

Instructions:

1. Remove the Old Felt

Start by removing the old felt from the bumpers. Use a flathead screwdriver to pry the staples out of the wood. Be careful not to damage the wood or the bumper.

2. Trim the New Felt

Cut the new felt to the correct size. The felt should be long enough to wrap around the bumper and overlap by about 1 inch. Trim the excess felt with scissors.

3. Attach the New Felt

Place the new felt over the bumper and staple it in place. Start by stapling the center of the felt, then work your way around the bumper, pulling the felt tight as you go. Make sure the staples are spaced evenly and are driven in all the way.

4. Trim the Excess Felt

Once the felt is stapled in place, trim the excess felt around the edges. Use a sharp knife or scissors to make clean, straight cuts.

5. Finishing Up

Finally, use a hammer to tap the staples down flush with the wood. This will help to prevent the staples from snagging on the pool balls.

Tips:

Use a high-quality pool table felt for best results.
Pull the felt tight as you staple it in place to prevent wrinkles.
Trim the excess felt carefully to avoid fraying.
If you are not comfortable with using a staple gun, you can use a hammer and tacks to attach the felt.

Conclusion:

Felting pool table bumpers is a relatively simple process that can be done at home with a few basic tools and materials. By following these instructions, you can keep your pool table looking and playing its best for years to come.