Larson Storm Door Retractable Screen Replacement

Replacing a Larson Storm Door Ret retractable Screen

Larson storm doors are popular choices for homeowners seeking added protection and insulation for their entryways. Many Larson storm doors are equipped with retractable screens, allowing for fresh air circulation while keeping out insects. Over time, these screens may wear out or become damaged, necessitating replacement. Replacing a retractable screen on a Larson storm door is a relatively straightforward process, but it requires a few tools and some basic knowledge of the door's mechanism.

Step-by-Step Guide to Replacing a Larson Storm Door Retractable Screen

To replace the retractable screen on a Larson storm door, follow these steps:

Remove the Old Screen
- Locate the release latch on the side of the screen frame. This latch is typically located near the bottom of the frame and may be concealed by a small cover.
- Depending on the model, the release latch may require a simple push or a twisting motion to release the screen. If the screen is stuck, carefully investigate the screen housing to identify any other release mechanisms. Consult the owner's manual if needed.
- Once the latch is released, carefully pull the screen out of its housing. It may be helpful to have a second person assist with this step, as the screen can be heavy and awkward to handle.
Prepare the New Screen
- Before installing the new screen, ensure that the screen frame is clean of any debris or dirt. If the existing screen frame is in good condition, a thorough cleaning may be all that is needed.
- If the screen frame is damaged, it may need to be replaced. Verify that the new screen is suitable for your Larson storm door model. Note that different Larson models may have different screen specifications, so it is critical to have the right replacement screen.
Install the New Screen
- With the new screen prepared, align it with the screen housing on the storm door. Ensure the screen is properly positioned and that the bottom guide rails slide into place.
- Carefully push the screen back into the housing, making sure it's securely seated. You may need to use some force to guide the screen into the housing, but avoid applying excessive force.
- Once the screen is fully installed, close the latch to secure it in place. If your screen uses a tensioning mechanism, ensure that it is properly tensioned for a good fit.

Troubleshooting Tips for Larson Storm Door Ret retractable Screens

Occasionally, you may encounter problems with a Larson storm door retractable screen that go beyond a simple replacement. Here are some common issues and possible solutions:

Screen Sticks or Binds: If the screen becomes stuck or binds, the problem may be due to dirt or debris accumulating in the track. Clean the track thoroughly using a vacuum cleaner or a brush, and then lubricate the track with silicone spray. Ensure that the screen's tension is properly adjusted.
Screen Won't Retract: Check the screen latch to see if it is properly engaged. If the screen is not completely retracted, manually guide it back into the housing. Check the tension of the screen and ensure proper alignment.
Screen Frame Is Damaged: If the screen frame is damaged, it will need to be replaced. Contact Larson, or a qualified repair service, to order the correct replacement frame. Ensure that the new frame is compatible with your storm door model.

Safety Recommendations for Replacing a Larson Storm Door Ret retractable Screen

When working with a Larson storm door retractable screen, it is essential to prioritize safety. Here are some safety recommendations:

Always wear safety glasses to protect your eyes from debris or accidental impacts.
Use caution when handling the screen as it can be bulky and heavy. Avoid pinching fingers during installation and retraction.
If the screen is damaged or broken, replace it immediately. A damaged screen may pose a safety risk.
If you are unsure about any step or encounter difficulties, consult the owner's manual or a qualified repair service. Attempting repairs beyond your expertise could lead to further damage or injury.